Thanks for the clarification.

I use Apple Pages (or emacs) instead of Word and can't be sure I wouldn't mess up the formatting or some other aspect of the word file if I edited it.

Here are a few suggestions and typos (unless noted, page numbers are from the v3.2 pdf):

Page 1: I suggest changing "OnSpeed Generation 2 Version 3.2 Assembly Procedure" to "OnSpeed Generation 2 Assembly Procedure Version 3.2."

Page 3: Eliminate one of "Soldering iron tip cleaning sponge" or "A small damp sponge for cleaning the tip of your soldering iron."

Page 5: This page is blank. (Thanks for fixing the front cover back photo.)

Page 9 & 10 of the v3.1 pdf: I thought the consolidated parts list was useful, even though it was somewhat redundant. It was perfect for doing the inventory of my Mouser order.

Page 19:

The following:

c) Install one of the 2.75-inch lengths on PS2 UPPER PORT 1.

d) Install one of the 2.25-inch lengths on PS2 LOWER PORT 2.

Should read:

c) Install one of the 2.75-inch lengths on PS2 UPPER PORT 2.

d) Install one of the 2.25-inch lengths on PS2 LOWER PORT 1.

Or better:

c) Install one of the 2.25-inch lengths on PS2 LOWER PORT 1.

d) Install one of the 2.75-inch lengths on PS2 UPPER PORT 2.

Page 25:

"...motion if the part relative to the pins." should read "...motion of the part relative to the pins."

@lostinsuisse Thank you, I'll update the assembly manual shortly.