Yup, possible if you have a Dynon AOA probe on the airplane. However, that would mean it's pretty simple to add T connections to the existing 1/4" lines to connect directly to the Gen 2 box. More accurate than using the Dynon AOA signal. You can get by with a single curve calibration in an RV-3/4/6/7/8 if you don't have a flap position sensor. RV-9/10/14 need a flap position sensor because of the slotted flaps on those airplanes.
Is it possible to run the GEN2 and install the software without having the pressure sensors installed, without blowing the unit up!I would like to fly with just the dynon hooked up until the automatic calibration is on board. I fly an rv7A.
Hi Dale,
Yup, possible if you have a Dynon AOA probe on the airplane. However, that would mean it's pretty simple to add T connections to the existing 1/4" lines to connect directly to the Gen 2 box. More accurate than using the Dynon AOA signal. You can get by with a single curve calibration in an RV-3/4/6/7/8 if you don't have a flap position sensor. RV-9/10/14 need a flap position sensor because of the slotted flaps on those airplanes.
Cheers,
Vac