The board files found through this link : PCB fabricated by PcbWay.com (affordable and quick turnaround circuit boards) https://www.pcbway.com/project/shareproject/OnSpeed_Gen_2_v3_0.html shown on https://github.com/flyonspeed/OnSpeed-Gen2/tree/master/Hardware does not match the Eagle board file also found on github. The parts project on the same page does seem correct. Found out when my boards arrived. Should have compared the zipped up Gerbers against the Eagle files before ordering.

$REBOOT! ets Jun 8 2016 00:22:57 rst:0xc (SW_CPU_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 188777542, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clock div:1 load:0x3fff0018,len:4 load:0x3fff001c,len:1044 load:0x40078000,len:8896 load:0x40080400,len:5816 entry 0x400806ac dhcps: send_offer>>udp_sendto result 0 This is what I see for the ESP when it reboots from the web page command. Is this normal? Especially the "send_offer". I ask because if I try to start LiveView, the ESP never sends out the command to the Teensy. Other commands, like List and Reformat the SD Card work fine. The format command shows up like this on ESP console: $FORMAT! and response comes back from Teensy that says card formatted and size. Meanwhile the Teensy console says this when you command LiveView and then List: $STOPLIVEDATA!STOPPED Live Data. (Wifi Request) $LIST!file list requested on Wifi Any ideas?

Hi Vac, Is there any version of Gen2 on Github. Trying to see how you handled the transition from Due to Teensy. Thx