Forum Posts

av888tor
Mar 10, 2020
In General Discussion
pics of alpha probe and info content media
0
1
153
av888tor
Mar 10, 2020
In General Discussion
My board is all finished and waiting for the enclosure (ordered) I have the Alpha systems probe which I purchased years ago with intent of buying their system later. My intent is to use the inspection port area under the right wing (left side has pitot tube). Cut the base plate to fit rib and doubler for the inspection port. Use counter sunk metal screws to mount then cut hold to match probe in inspection plate. Tubing is in place in conduit. Set the angle of the probe at 50 degrees from the chord line. Any comments as to location and angle? Mark
0
2
110
av888tor
Feb 26, 2020
In General Discussion
I love the next day delivery I usually get from mcmaster carr. However, for the tubing the minimum amount is 25 ft. for either size of tubing. Another source but probably not as fast is shown below. I will share what I don't use.. just send me your address
tubing source
 content media
0
2
85
av888tor
Feb 12, 2020
In General Discussion
Hi Gang all set to solder up the board intend on using the same order of assembly as V2 instructions. and that means starting with the capacitors. With the pDf that Lenny sent and the markings on the board I am comfortable as to location of components. I understand how tell the polarity of the each capacitor but getting the positive on the right track has me baffled. I checked the schematic and maybe I can follow the tracks to determine ground. seems a little risky. av888tor/gmail.com Mark Wyss
0
1
103
av888tor
More actions